Make sure the CubeX software is not open on your computer. Re-flashing the firmware wouldn't be a bad idea.įollow these steps to update the firmware:Ģ. I plan on calling up Cubify and seeing what they say should be replaced. I have ordered a new z-gap sensor that relocated the sensor to another location on the machine, but this will probably not arrive until next week.
So I am curious if others have experienced this type of issue and if they have any ideas on what needs to be replaced or how to fix it. Infact after every failed print, after I go and check the print tip visible covered with filament which in turn caused the flow error to begin with. I believe this is because it is losing its positioning and is to close to the actual print that it is jamming up. I will hear a knocking in the extruder which sounds like it having problems feeding the material onto the print. It is having problems laying down layers after the first layer on the bed. The second issue I am having is with just prints now, even with the above problems I was able to get it printing and now that just is not happening anymore. I have to stop the printer, manually move the printer to the home position and power it down completely to get it to reset its position and work.
The first being after I do a z-gap align, when it is going back to the home position it is losing its positioning and just slamming into the side of the printer. I have two issues, that I believe are related.
I was able to get a few months out of the printer working just fine until now. After everything was done it seemed the breakout board on my printer was fried and that was what was causing the issue. A few month ago, I basically replaced everything on my cubex printer mainboard, breakout board, hot tip, feeding servo, and the z-gap sensor.